CADDX NX-6 Manual de instalación descargar pdf (Pagina 90)

GE Security

BOARD INSTALLATION

Diagram 1:

Inside the can, several 2-holed insertion points have been constructed. This allows for either

vertical or horizontal placement of the modules. Notice that each insertion point has two sizes

of holes -a larger hole and a smaller hole.

The black plastic PCB guides are grooved on one edge where

the PC board will be seated. The end with the half-moon protrusion fits into

the larger hole. The smaller hole is for the screw.

Diagram 2:

Place the first black plastic PCB guide in the top insertion point,

grooved edge downward. The half-moon protrusion will be in the large hole.

It does not require force. Insert one of the provided screw into the smaller

hole (from inside the can) to secure it in place. A screwdriver should reach

through the notch that runs the length of the guide to tighten the screw. The

second PBC guide should be positioned opposite the first (grooved edge up)

and placed in the lower insertion point, using the same procedures

described above. Once mounted, screw it in securely.

Diagram 3:

The PC Board should slide freely in the grooves of both guides.

NX-6-EUR Installation manual Page 90 23/12/04

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 103 104

Sin comentarios

CADDX NX-6 Manual de instalación Pagina 90