CADDX NX-6 Manual de instalación descargar pdf (Pagina 65)

GE Security

LOCATION 78 - CLOSING COMMUNICATOR CODE, SLOW SPEED FORMATS ONLY (8 segments,

numerical data)

Location 78 contains the tens digit for a 4+2 and 3+1 format if “Closing Reporting” is

enabled. For a 4+2 format, the digit programmed in this section will be sent as the tens

digit of the alarm event code. As ones digit, the user number (1-F) will be reported (e.g.

code 16 = 1, code 40 = A). This location contains 8 segments. Any segment left as “0” will

follow the segment 1 selection. Segments 1-3 contain the closing code per bank of 15

codes. Segments 4-8 are reserved.

If you need to report openings and closings with a unique code per user, Contact ID or

SIA format must be used.

Segment 1

Codes 1-15, “Closing Code”

Segment 2

Codes 16-30, “Closing Code”

Segment 3

Codes 31-40, “Closing Code”

Segment 4-8

Reserved

LOCATION 79 - AUTOTEST COMMUNICATOR CODE, SLOW SPEED FORMATS ONLY (2 segments,

numerical data)

Location 79 contains the tens and ones digits for a 4+2 and 3+1 format that will be sent if

“Autotest” or “Manual Test” is enabled. Segment 1 contains the tens digit, and segment 2

contains the ones digit.

For a 3+1 format, only the segment 1 digit (tens) will be sent.

LOCATION 80 - RECENT CLOSING AND EXIT ERROR COMMUNICATOR CODE, SLOW SPEED

FORMATS ONLY (2 segments, numerical data)

Location 80 contains the tens digit for a 4+2 and 3+1 format that will be sent if “Recent

Closing” and/or “Exit Error Reporting” are enabled. Segment 1 contains the tens digit for

the “Recent Closing Reporting”. Segment 2 contains the digit for the “Exit Error

Reporting”. As ones digit, the user number (1-F) of the user who closed, will be sent. If

you need to report Recent Closings and Exit Errors with a unique code per user, Contact

ID or SIA format must be used.

LOCATION 81 - START PROGRAM AND END PROGRAM COMMUNICATOR CODES, SLOW SPEED

FORMATS ONLY (4 segments, numerical data)

Location 81 contains the tens and ones digits for a 4+2 and 3+1 format that will be sent if

“Start / End Programming Reporting” is enabled. Segment 1 contains the tens digit of the

“Start Program Reporting”. Segment 2 contains the ones digit of the “Start Program

Reporting”. Segment 3 contains the tens digit of the “End Program Reporting”. Segment 4

contains the ones digit of the “End Program Reporting”.

For a 3+1 format, only the segment 1 digit resp. segment 3 digit (tens) will be sent.

NX-6-EUR Installation manual Page 65 23/12/04

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 103 104

Sin comentarios

CADDX NX-6 Manual de instalación Pagina 65