CADDX NX-6 Manual de instalación descargar pdf (Pagina 37)

GE Security

LOCATION 5 - PARTITIONS REPORTED TO PHONE N° 1 (1 segment, feature selection data)

Location 5 is used when the events to be reported to a phone number are based on the

partition, regardless of the event. If you use this location, you should program location 4

as “0”.

Segment 1

1 = Partition 1

2 = Partition 2

3-8 Reserved

Telephone number 2

LOCATION 6 - PROGRAMMING PHONE N° 2 (20 segments, numerical data)

Phone N°2 is programmed in location 6. A “14” indicates the end of the phone number.

Delays of four seconds can be programmed at any point in the phone number by

programming a “13” in the appropriate segment. The system will always wait for a dial

tone unless the first digit of the phone number is a “13”; in this case, it will only delay.

Tone (DTMF) dialling is default. If you want pulse tone dialling, program a “15” in the

segment where pulse dialling should begin. If the entire number should be pulse dialling,

program a “15” in the first segment. Program an “11” for a “*”, and a “12” for a “#”.

Note: a zero is programmed as a “0”.

LOCATION 7 - ACCOUNT CODE FOR PHONE N° 2 (6 segments of numerical data)

Use location 7 to program the account code that is sent when phone N°2 is dialled. A

zero in the account code is programmed as a “0”. A “10” indicates the end of the account

code, so program a “10” in the segment immediately after the last digit of the account

code. If the account code is 6 digits long, program all 6 segments. If this location is left

unprogrammed, account code 1 will be used when the second phone number is dialled.

LOCATION 8 - COMMUNICATOR FORMAT FOR PHONE N° 2 (1 segment, numerical data)

Location 8 contains the communicator format used to transmit to the receiver that is

connected to phone N°2. Consult the instruction manual for your central station receiver

in order to determine which format is compatible, and select from the 15 formats listed on

page 33. If you require a format other than those listed, review the override options

described in Location 18 to create the appropriate format. In order to create a special

format, a “15” must be programmed in location 8, in addition to the entries in location 18.

If this location contains a “0”, format 1 will be used when phone N°2 is dialled.

NX-6-EUR Installation manual Page 37 23/12/04

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 103 104

Sin comentarios

CADDX NX-6 Manual de instalación Pagina 37