CADDX NX-6 Manual de instalación descargar pdf (Pagina 67)

GE Security

Programming partition parameters

LOCATIONS 88-109 ARE FOR PROGRAMMING DIFFERENT ACCOUNT CODES

AND/OR FEATURES FOR EACH PARTITION. IF A LOCATION IS LEFT

UNPROGRAMMED, THE FEATURE FOR PARTITION 1 AND THE ACCOUNT CODE

FOR THE PHONE NUMBER WILL BE USED

LOCATION 88 - ACCOUNT CODE FOR PARTITION 1 (6 segments, numerical data)

Location 88 contains the account code that is sent when partition 1 is reported. If location

88 is left unprogrammed (all “10”s), then the account code corresponding to the phone

number that is dialled will be used. If the account code is less than six digits, program a

“10” in the segment immediately after the last digit of the account code. If the account

code is 6 digits long, program all 6 segments.

LOCATION 89 - ACCOUNT CODE FOR PARTITION 2 (6 segments, numerical data)

Location 89 contains the account code that is sent when partition 2 is reported. If location

89 is left unprogrammed (all “10”s), then the account code corresponding to the phone

number that is dialled will be used. If the account code is less than six digits, program a

“10” in the segment immediately after the last digit of the account code. If the account

code is 6 digits long, program all 6 segments.

LOCATION 90 - PARTITION 2 FEATURE AND REPORTING SELECTIONS (5 segments, feature

selection data)

Location 90 is used to enable certain features that the user can access or see from the

keypad of the system. In addition, certain communicator reports are enabled in this

location. Each of these features can be enabled by partition. This location contains 5

segments, with eight possible features per segment. Refer to location 23 for the feature

selections. If all the segments are blank (nothing enabled), the features for partition 1 will

be used.

LOCATION 91 - PARTITION 2 ENTRY EXIT TIMERS (6 segments, numerical data)

Location 91 is used to enter the entry and exit times, in seconds. There are 2 separate

entry and exit times. Valid entries are 10-255 seconds. If all the segments are “0”, the

entry and exit times for partition 1 will be used.

Segment 1

Entry time 1

Entry time that will be used when a delay 1 zone

type initiates an entry delay

Segment 2

Entry time 2

Exit time that will be used for all zones designated

as delay 1

Segment 3

Entry time 3

Entry time that will be used when a delay 2 zone

type initiates an entry delay

Segment 4

Entry time 4

Exit time that will be used for all zones designated

as delay 2

Segment 5

Reserved

Segment 6

Reserved

LOCATION 92-109 - RESERVED

NX-6-EUR Installation manual Page 67 23/12/04

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 103 104

Comentarios a estos manuales

Sin comentarios

CADDX NX-6 Manual de instalación Pagina 67

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad CADDX NX-6