CADDX NX-6 Manual de instalación descargar pdf (Pagina 18)

GE Security

Programming the NX-148 LCD keypads

This section describes how to program the address and partition for each keypad, and it

also explains the options that are available. The address of the keypad is important

because the panel uses it to supervise the keypads.

The factory default for the Master code is [1]-[2]-[3]-[4] when using a 4-digit code, or [1]-

[2]-[3]-[4]-[5]-[6] for a 6-digit code. The factory default for the “Go To Program” code is

[9]-[7]-[1]-[3] when using a 4-digit code, or [9]-[7]-[1]-[3]-[0]-[0] for a 6-digit code.

[*]-[9]-[1] ADJUSTING THE VIEW / BRIGHTNESS OF THE LCD

1. Enter [*]-[9]-[1] The LCD screen will prompt for a “master” code.

2. Enter [master code]

The LCD will now prompt you to increase or reduce

the viewing angle. By using the scroll keys to the

right of the LCD, you can increase or reduce the

text-viewing angle.

To advance to the brightness

option, press [*]

The LCD will prompt you to brighten or dim the

LCD lighting. Use the scroll keys again to set the

desired brightness. When completed, exit by

pressing [*].

[*]-[9]-[2] PROGRAMMING CUSTOM MESSAGES IN THE KEYPAD

1. Enter [*]-[9]-[2]

The LCD screen will prompt for the “Go To

Program” code.

2. Enter [program code]

The LCD will now prompt you to enter the message

number followed by [#]. Zones 1 through 16 custom

messages are message numbers 1-16

respectively.

Message 193 - Custom message top line.

Message 194 - Custom message bottom line.

Message 195 – Shutdown message top line.

Message 196 – Shutdown message bottom line.

Enter message number to

edit, followed by [#]

The LCD will display the zone number on the top

line. The zone description will be displayed on the

bottom line. Use the instructions on page 29-30 to

edit character data.

When finished, exit by pressing [EXIT] while the LCD screen is prompting for a

zone message #. Any changes will automatically be copied to all other LCD

keypads in the system. NOTE: If you want a LCD keypad to have a different custom

message, you must enable custom message lock under the [*]-[9]-[3] function.

NX-6-EUR Installation manual Page 18 23/12/04

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 103 104

Comentarios a estos manuales

Sin comentarios

CADDX NX-6 Manual de instalación Pagina 18

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad CADDX NX-6