CADDX NX-6 Manual de usuario descargar pdf

GE/CADDX

NX-8e

INTRODUCTION

This Application Note describes how to interface a JDS STARGATE controller to a GE/CADDX NX-8, NX-6 or NX-4 or NX-8e

security system. The NX-8 can be expanded to 48 zones maximum. The NX-8e can be expanded to 192 zones maximum.

STARGATE supports the first 64 zones.

STARGATE takes full advantage of all GE/CADDX security functions including:

• Arm or disarm the system

• Home and Away modes

• Bypass or Unbypass zones

• Turn the keypad chime mode on and off

• Monitor and act upon partition and zone changes

• Automatically set the alarm panel’s clock

• Track the status of the security system

• Detect alarm conditions

• Detect zone trouble conditions

• User Number

• More

The GE/CADDX NX-8, NX-6 or NX-4 requires the optional NX-584 serial interface in order to communicate with Stargate.

The GE/CADDX NX-8e requires a P0003 adaptor kit to provide a serial connection.

Support for GE/CADDX NX panels requires Version 3.00 (or higher) Firmware/Software for the JDS STARGATE controller.

The GE/CADDX NX panel connects to COM2 or COM3 of STARGATE.

The typical configuration consists of the GE/CADDX NX-8 security panel w/ NX-584 serial interface or NX-8e security panel

with P0003 adaptor kit and at least one GE/CADDX LCD type keypad (for alarm system programming and backup for alarm

system control).

GE/CADDX NX-584

Serial Interface

STARGATE

DB9-RJ11

adaptor

6-conductor

DATA cable

Connection to GE/CADDX NX-8 Connection to GE/CADDX NX-8e

P0003 Adapter

(plugs into connector J11

on NX-8e circuit board -

red stripe toward back)

6-conductor

DATA cable

STARGATE STARGATE

GE/CADDX

NX-8

NX-584

Application Note 4.3

Interfacing STARGATE to a GE/CADDX

NX-8/6/4 or NX-8e Security System

APPLICATION NOTE 4.3

3 wire connection

to GE/Caddx panel

keypad terminals

STARGATE

DB9-RJ11

adaptor

1 2 3 4 5 6

Application Note 4.3 1
NX-8/6/4 2

Indice de contenidos

Pagina 1 - Application Note 4.3

GE/CADDXNX-8eINTRODUCTIONThis Application Note describes how to interface a JDS STARGATE controller to a GE/CADDX NX-8, NX-6 or NX-4 or NX-8esecurity

Pagina 2 - NX-8/6/4

INSTALLATION AND SETUPFollow the steps described below to install and configure the system.1) Install Security SystemYou must first install the securi

Pagina 3

SECURITY SYSTEM COMMANDSThe following security system commands can be used as THEN - SECURITY actions anywhere in your schedule.Arm partition in Home

Pagina 4

SECURITY SYSTEM CONDITIONSThe following security system conditions can be used as IF - SECURITY conditions anywhere in your schedule.Transition Activ

Pagina 5

SECURITY SYSTEM CONDITIONSThe following security system conditions can be used as IF - SECURITY conditions anywhere in your schedule.Partition ARMEDTh

Pagina 6

SECURITY SYSTEM CONDITIONS (Cont’d)Zone is in trouble conditionThis condition is true if the specified zone is currently in a “trouble” condition.Zone