CADDX NX-6 Manual de instalación descargar pdf (Pagina 10)

GE Security

Guard codes (Sweden)

User codes 16 and 17 can be considered as so called “guard codes”. In this case, user

codes 16 and 17 cannot be programmed or changed anymore via a master code. They

can only be changed via downloading. Guard code 16 will be able to arm/disarm at any

time. Guard code 17 will only be able to arm/disarm during an alarm condition. Only

when an alarm condition occurs, guard code 17 will be able to disarm the system. After

having evaluated the alarm condition, guard code 17 can arm the system again but will

not be able to disarm anymore (see location 41, segment 1, option 7).

Group bypass

A designated group of zones can be programmed to bypass by pressing [Bypass]-[0]-[0]-

[Bypass] prior to arming (see locations 111-169 segment 2).

Immediate restore by zone

The NX-6 can be programmed to send alarm and restore reports as soon as they occur,

or to wait until the siren time has expired or the system has been disarmed. (see location

37 segment 2).

Internal event log

Up to 512 events can be stored in memory together with the date and time of the event.

These events can be viewed later on via the LCD keypad, or by downloading. All

reportable events are reported to the log.

Keypad activated panics

The NX-6 has three keypad activated panics that will send reports to the central station,

auxiliary 1 (Fire), auxiliary 2 (Medical) and keypad panic. Auxiliary 1 will activate the

steady (Fire) siren, auxiliary 2 will sound the keypad, and the keypad panic can be

programmed to be silent or audible (see location 23 segment 1).

Keypad shutdown mode

This feature will extinguish all the LED’s on the keypad, except the “Power” LED, after 60

seconds have elapsed without a keypress. Pressing a valid user code (not an installer

code) will light up all the LED’s (see location 41, segment 1, option 5). This option

requires bilingual LCD keypads. This option is an alternative for LED-extinguish.

Keypad sounder control

The NX-6 can be programmed to sound the keypad sounder for certain events (see

location 39).

Keypad tamper

If this option is enabled, the NX-6 will disable the keypad for 60 seconds, and will

communicate a tamper signal to the central station whenever 30 keypresses are entered

without producing a valid code (see location 23 segment 1).

Keyswitch arm/disarm

Any zone on the NX-6 can be programmed as a momentary or maintained keyswitch

zone. If a zone has been programmed as a momentary keyswitch, momentary shorts on

this zone will arm/disarm the control. A zone can be also being programmed as a

maintained keyswitch. The control panel will be armed as long as such a zone is shorted.

If opening/closing reports are sent, the user code will be 99 (see “default zone

configurations”)

LED extinguish

This feature will extinguish all the LED’s on the keypad, except the “Power” LED, after 60

seconds have elapsed without a keypress. Pressing any numeric key will light up all the

LED’s (see location 23 segment 2).

NX-6-EUR Installation manual Page 10 23/12/04

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 103 104

Comentarios a estos manuales

Sin comentarios

CADDX NX-6 Manual de instalación Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad CADDX NX-6