CADDX NX-6 Manual de instalación descargar pdf (Pagina 20)

GE Security

Remark : In the menu “Select an option” 8 additional options can be selected. The

options 5 until 8 are not used for the moment and may therefore not be

selected. The options 1 and 4 are described below:

Option 1 :

On the LCD screen “press * for help”. By this the status of the system

and the message “press * for help” are alternately displayed on the LCD

screen. This is only to inform the user of the user’s menu.

Option 2 :

Light continuously on. By this the lights of the LCD display and the keys

will continue to light up, independently of the programming of the control

panel. (Adr 23, Segm. 2, option 1 = turn off the lights after one minute of

inactivity).

Option 3 : ON if PIN should be hidden when programming user codes.

Option 4 : ON suppresses beeps when an RF transmission is lost.

Option 5 : Reserved (Do not program).

Option 6 : Disable ARM and BYPASS led for Norway/Sweden (NX-148E v3.47)

Option 7-8 : Reserved (Do not program).

[*]-[9]-[4] SET KEYPAD NUMBER AND PARTITION

1. Enter [*]-[9]-[4] The LCD screen will prompt for a code.

2. Enter [program code]

The LCD will now prompt you for the keypad

number followed by [*]. The current keypad number

will be displayed in the lower right hand corner.

Enter the keypad number

followed by [*]

The LCD will now prompt you for the partition

number. The current partition will be displayed in

the lower right hand corner.

Enter the partition number for

the keypad

The keypad will automatically exit this mode now.

NX-6-EUR Installation manual Page 20 23/12/04

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 103 104

Sin comentarios

CADDX NX-6 Manual de instalación Pagina 20