CADDX Ranger 9000E Manual de usuario descargar pdf (Pagina 17)

13Using the Alternate Mounting Kit

Step 3: Attach the mounting bracket to the wall

• Screw the mounting plate onto the

wall using the anchors and the wall

screws

a. Place the mounting plate over the

anchors so that the screw holes on

the mounting plate line up with the

holes on the anchors.

b. Insert one of the long screws

through the screw hole on the

mounting plate and into the

corresponding anchor hole.

c. Use the Phillips-head screwdriver (or

your drill with a crosspoint bit) to

tighten the screw into the anchor.

d. Repeat this action for the remaining

three wall screws.

Step 4: Attach the screws

to the uControl Link

• Screw the small screws into the back of

the uControl Link

a. Put the uControl Link on a flat surface

and make sure that the back side is

facing upward.

b. Place the four small screws into the

screw holes on the back of the uControl

Link.

c. Use the Phillips screwdriver to screw in

the screws.

Attention: When you screw in the

screws, make sure that the screws do not

go into the uControl Link all the way.

You must have a small amount of space

between the back of the uControl Link

and the built-in washer on the screw.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 41 42

Sin comentarios

CADDX Ranger 9000E Manual de usuario Pagina 17