CADDX Ranger 9000E Manual de usuario descargar pdf (Pagina 12)

Disconnect Existing Cellular Hardware8

Step 2: Remove the existing cellular device wires from

the auxiliary power ports

The cellular device draws power from either the auxiliary power ports on the

security systems circuit board inside the alarm box or a transformer that is

plugged into a nearby outlet.

For auxiliary power connections, most cellular devices use two wires to connect to

the positive (AUX+) and negative (AUX-) auxiliary power ports on the alarm

circuit board. There might be several sets of wires connected to these ports. It is

important that you locate the specific wires from the cellular device and remove

only these wires from the auxiliary power ports.

Attention: For information about auxiliary power ports for your alarm model,

see the section “Auxiliary Power and Keypad Ports” on page 21 to find the ports

corresponding to your alarm model.

WARNING: If the wires for the cellular device are intertwined with other wires

that feed into the auxiliary power ports, you need to remove all the wires and

untangle the cellular device wires. After you separate the cellular device wires,

make sure that you reinsert the remaining wires and secure them back inside the

auxiliary power ports.

• Remove the cellular device wire from

the positive (AUX+) port

a. Use the screwdriver (contained in the kit) to

loosen the screw on the AUX+ auxiliary

power port only enough to pull out the

existing cellular device wire.

b. Remove the existing cellular wire from the

AUX+ port. Make sure that the other wires

do not slip out of the port.

c. Hold the wires in place and tighten the screw

firmly to secure the remaining wires to the

AUX+ port.

• Remove the cellular device wire from

the negative (AUX-) port

a. Use the screwdriver to loosen the screw on

the AUX- auxiliary power port only enough

to pull out the existing cellular device wire.

b. Remove the existing cellular wire from the

AUX-port. Make sure that the other wires do

not slip out of the port.

c. Tighten the screw firmly to secure the

remaining wires to the AUX- port.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 41 42

Sin comentarios

CADDX Ranger 9000E Manual de usuario Pagina 12