
49
APPENDIX 1
This document describes the 9000E reporting event codes when using the SIA format (format 14). The following
codes are programmable and are sent when the Data 1 location is programmed as the event code. For zones,
programming a "0" as the Data 1 location will result in an automatic selection of the event code depending on the
zone type choosing from Fire, Panic, or Burglary. The Data 2 and Data 3 are then sent as a Zone Identifier.
PROGRAMMED DATA 1 SIA CODE DEFINITION
1 FA Fire Alarm
2 PA Panic Alarm
3 BA Burglary Alarm
4 GA Gas Alarm
5 KA Heat Alarm
6 WA Water Alarm
7 QA Emergency Alarm
8 SA Sprinkler Alarm
9 UA Untyped Alarm
10 HA Holdup Alarm
11 MA Medical Alarm
12 ZA Freeze Alarm
13 TA Tamper Alarm
14 RP Periodic Test
15 Reserved
The following event codes are fixed, but must be enabled by programming a 1 in the corresponding location.
REPORTING EVENT SIA CODE PROGRAMMING LOCATION
Keypad Tamper TA 336
Autotest RP 340
Opening OP 348
Closing CL 350
Cancel OC 354
AC Loss AT 356
Low Battery YT 360
Restore Code *R 364
Bypass Code *B 368
Bypass Restore *U 368 / 364
Trouble Code *T 372
Trouble Restore *R 372 / 364
AC Restore AR 376
Battery Restore YR 376
Expander Trouble ET 378
Expander Trouble Restorer ER 511
Fail to Close CL 592
Early Opening OK 588
Download Complete RS 596
RF Loss of Supervision ET (For these two - see
RF Sensor Low Battery XT 9090 Installation Manual)
* The character transmitted in this slot will be the first character in the SIA code from the top list for the event
being reported. If a "1" is programmed in location 364, and a Burglary Alarm (BA) restores, a BA will be
transmitted. If a "1" is programmed in location 372, and a Fire Alarm (FA) zone goes into Trouble, an (FT) will
be transmitted.
Comentarios a estos manuales