CADDX 8600 Manual de usuario descargar pdf (Pagina 7)

RESETTING YOUR SECURITY CONTROL CENTER

In the event of a system malfunction in the Security Control Center, press the [#] (reset) key

on the keypad control. This should reset the code sequence and restore normal operation. If

the problem persists, call the service number located on page 1 of this booklet for service.

AUDIBLE ALARM SOUNDS

FIRE: Steady siren, pulsing bell (see page 1) or beeping keypad.

INTRUSION & PANIC: Yelp siren, steady bell (see page 1) and beeping keypad.

KEYPAD CONTROL LIGHT INDICATORS

ARMED RED: On when system is armed; off otherwise. Flashes for alarm memory if alarm

was activated during arming cycle.

READY GREEN: On when all zones are secure and/or Bypassed and the system is ready

to arm; off otherwise. Flashes for telephone line fault.

INSTANT RED: On when the entry/exit zones are instant; off otherwise.

POWER RED: On when AC power is on; off otherwise. Flashing when the system standby

battery is low.

ZONES YELLOW: Flashing means unsecured. Steady means bypassed. Off means

secure.

KEYPAD CONTROL TONES (BEEPS)

A sounder is built into the keypad and may sound for any of the followin

reasons:

 Beeps for all keypresses.

 Sounds a continuous tone during the Entry delay time.

 Pulses when a day zone is violated while the system is disarmed.

 Pulses when a FIRE zone has a trouble condition; there is a low battery, or bell circuit

trouble.

 Pulses when the armed status changes and the AC power is off.

 Beeps 3 times for trying to arm with the "READY" light off, if "FORCE ARMING" has not

been selected.

 Beeps 1 second for the "CHIME" feature.

 Beeps 1 second at the end of the exit delay.

 Beeps to indicate telephone line fault if selected.

 Beeps 1 long beep followed by 3 short beeps to alert you that there are only ten seconds

remaining in the exit delay.

When pulsing, the keypad sounder may be silenced by entering a valid code. The arm/disarm

state of your system will not change when entering a code to silence a pulsing keypad

sounder.

1 2 3 4 5 6 7 8 9 10

Sin comentarios

CADDX 8600 Manual de usuario Pagina 7