CADDX NX-408E-I Especificaciones descargar pdf (Pagina 4)

NX-1700E Card Reader

V. PROGRAMMING

A. USING THE LED KEYPAD

NOTE: The NX-108E / NX-116E / NX-124E series keypads should not be used to program user cards.

ACTION

RESULT

ENTERING THE PROGRAM MODE

& Á _

x x x x x x x x

Enters the Program Mode.

Stay, Chime, Exit, Bypass & Cancel LEDS will flash.

& [Go To Program Code]

Factory Default is `^XZ

x x x x x x x x

If the "Go To Program Code" is valid, the "Service" LED will flash and the 5

function LEDs will illuminate steady. You are now in the Program Mode

and ready to select the module address.

ENTERING THE MODULE ADDRESS

Scan a card. x x x x x x x x The card reader will address itself.

& XYW #

(example only)

x x x x x x x x

Enters the module address. Refer to Table IV-1 on page 3 for the address

assigned by the card reader module itself.

The Armed LED will illuminate while it is waiting for a programming

location to be entered.

PROGRAMMING A LOCATION



If an attempt is made to program an invalid entry for a particular segment, the keypad sounder will emit a

triple error beep (beep, beep, beep), and remain in that segment awaiting a valid entry.

To Enter a Location:

& [location] #

x x x x x x x x

The Armed LED will flash. If the location is valid, the "Armed" LED will

extinguish, the "Ready" LED will illuminate, and the zone LED’s will show

the data for the first segment of this location.

To Change Location Data:

& [changed data]

x x x x x x x x

The "Ready" LED will flash to indicate a data change in process and will

continue until the data is saved.

& À

x x x x x x x x

The new data is saved.

The keypad will increment and display the next segment’s data.

NOTE: Repeat these steps until the last segment is

reached.

To Exit a Location:

& #

x x x x x x x x

Exits from this location. The “Ready” LED will extinguish. The "Armed" LED

will illuminate waiting for a new programming location to be entered.

To Review The Data:

& [location] #

x x x x x x x x

The Armed LED will flash. If the location is valid, the "Armed" LED will

extinguish, the "Ready" LED will illuminate, and the zone LED’s will show

the data for the first segment of this location.

& À

x x x x x x x x

(Do not enter data.)

The next segment is displayed. Each time Á is pressed, the data of the

next segment will be displayed for review.

Shortcuts:

Previous location.

Same location.

Next sequential location.

1 2 3 4 5 6 7 8 9 ... 15 16

Comentarios a estos manuales

Sin comentarios

CADDX NX-408E-I Especificaciones Pagina 4

Comentarios a estos manuales

Relacionado con productos y manuales para Receptor CADDX NX-408E-I