CADDX NX540 Manual de instalación descargar pdf (Pagina 13)

NX-4 Control

Page 13

FORMAT SELECTIONS

DATA FORMAT DESCRIPTION

0 Local Communicator is disabled

1 Universal 4+2

Two digit event code 1800hz transmit 2300hz handshake double round parity

40pps

2 3+1 fast (or 4+1)

One digit event code 1900Hz transmit 1400Hz handshake double round parity

20pps

3 Reserved Reserved

4 Pager 2 digit event code DTMF transmission

5 3/1 or 4/1 slow 1800hz transmit 2300hz handshake double round parity 20 p.p.s. hex capability

6 3/1 or 4/1 slow 1800hz transmit 1400hz handshake double round parity 20 p.p.s. hex capability

7 3/1 or 4/1 fast 1800hz transmit 2300hz handshake double round parity 40 p.p.s. hex capability

8 3/1 or 4/1 fast 1800hz transmit 1400hz handshake double round parity 40 p.p.s. hex capability

9 3/1 or 4/1 fast with

parity

1800hz transmit 2300hz handshake single round w/parity 40 p.p.s. hex capability

10 3/1 or 4/1 fast with

parity

1800hz transmit 1400hz handshake single round w/parity 40 p.p.s. hex capability

11 4+2 express 2 digit event code DTMF transmission

12 4+2 fast

Two-digit event code 1900hz transmit 1400hz handshake double round parity 20

p.p.s.

13 Ademco Contact ID DTMF (see pages 33-34)

14 SIA FSK (see pages 33-34)

15 Custom format (See location 18, page 16)

REPORTING EVENTS TO PHONE NUMBER 1

Location 4 is used to select which events are reported to Phone #1. If dual or split reporting is not desired, location

4 should be used to select all events to Phone #1. If dual or split reporting is desired, location 4 should be used to

select only those events that should be reported to Phone #1. If no events should be reported to Phone #1, location

4 should be programmed as "0" (disabled).

LOCATION 4 - EVENTS REPORTED TO PHONE # 1 (2 segments, feature selection data)

Segment 1: 1 = Alarms and Alarm Restores.

2 = Opening and Closings.

3 = Zone Bypass and Bypass Restores.

4 = Zone Trouble and Trouble Restores.

5 = Power Fail, Low Battery, Power Restore, and Low Battery Restore.

6 = Bell Cut, Bell Cut Restore.

7 = Test Reports.

8 = Start and End programming, Download complete.

Segment 2: 1 = Zone and Box Tamper and Tamper Restore.

2 = Auxiliary Power Over-current and Restore.

3 = Wireless Sensor Missing and Restore.

4 = Wireless Sensor Low Battery and Restore.

5 = Expander Trouble and Restore.

6 = Fail To Communicate.

7 = Reserved.

8 = Reserved.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 41 42

Comentarios a estos manuales

Sin comentarios

CADDX NX540 Manual de instalación Pagina 13

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad CADDX NX540