CADDX NX-416E Especificaciones

NetworX NX Series Receiver ModulesPage 1NetworX NX Series Receiver ModulesDocument Number: 466-1427 Rev. EAugust 1998InstallationInstructionsProduct S

Page 10NetworX NX Series Receiver Modules5) Enter [4] [9] [#] to enter the sensor learning location. The Ready LED should turn on and the Armed LED sh

NetworX NX Series Receiver ModulesPage 118) Press [✻] to save any changes. The panel is now wait-ing for the next location entry.Note: Pressing [#] do

Page 12NetworX NX Series Receiver Modules5) Enter the tripped transmitters’ location.6) Observe keypad light 7 which should be on, indicating the tran

Page 2NetworX NX Series Receiver Modules3) Install the module into the cabinet by turning the stand-off sideways, then slide the module up onto the gr

NetworX NX Series Receiver ModulesPage 35) Apply power to the NX-8. The middle (red) LED on the module should start blinking. Table 2 describes the mo

Page 4NetworX NX Series Receiver ModulesTable 3. Module Programming Worksheet TableLocation Segment 1 Segment 20 (Supervi-sion)1 - Normal ______hrs.(0

NetworX NX Series Receiver ModulesPage 510 (Zone 10)Assigned to module #_____.1 - Enable sensor ❏2 - Supervised ❏3 - Input option 1 ❏4 - Input option

Page 6NetworX NX Series Receiver Modules20 (Zone 20)Assigned to module #_____.1 - Enable sensor ❏2 - Supervised ❏3 - Input option 1 ❏4 - Input option

NetworX NX Series Receiver ModulesPage 730 (Zone 30)Assigned to module #_____.1 - Enable sensor ❏2 - Supervised ❏3 - Input option 1 ❏4 - Input option

Page 8NetworX NX Series Receiver Modules40 (Zone 40)Assigned to module #_____.1 - Enable sensor ❏2 - Supervised ❏3 - Input option 1 ❏4 - Input option

NetworX NX Series Receiver ModulesPage 9Enroll the ModuleThe following steps describe how to enroll and program the module to be supervised by the NX-